• It is acceptable to extend a leg segment only partially if necessary to achieve a
specific height, but do not partially extend several segments of the same leg.
• Standard working height: the tripod has four leg segments, pull out the first
three fully and leave the fourth one inserted. This results in a working height
of approx. 148 cm, which allows an ergonomic operation of the scanner. Only
pull out the smallest leg segments when you need a larger tripod height.
• The tripod is equipped with large adjustable rubber feet. Each time you move
the tripod, check to ensure that the feet are correctly resting on the ground. If
you need to place the tripod on unstable ground (e.g., grass, gravel, mud) use
the supplied spikes instead of the rubber feet. Press the spikes individually into
the ground until they reach a stable, load-bearing layer.
• After you set the tripod on the ground, check the leg latches. If any of the
latches are loose, spread the legs slightly until the latches cannot be wiggled.
This ensures that the tripod is firmly planted on the ground, and unlikely to
shake or vibrate during scanning.
To Next Page
Loading...
