Why is my GIWEE Air Conditioner blowing mist?
When the room humidity is relatively high, the cooling or defrosting process in heating mode ends, the air outlet may release water mist. This is a normal physical phenomenon.
What to do if GIWEE Air Conditioner won't stop blowing air after shut down?
If your GIWEE Air Conditioner doesn't blow air immediately after shutting down in cooling mode, the drying function may be enabled. Wait for it to finish, or use the remote to disable it. Also, the louver will close after 30 seconds.
Why is no air blowing out at the start of heating operation in GIWEE COU-D18HR4-A01-S40 Air Conditioner?
If your GIWEE Air Conditioner doesn't blow air when starting heating, it's preventing cold air from blowing until the indoor heat exchanger warms up. This usually takes 2 to 5 minutes.
Why is my GIWEE Air Conditioner not blowing air for 6-12 minutes in heating mode?
If your GIWEE Air Conditioner doesn't blow air for 6 to 12 minutes in heating mode, it might be defrosting automatically due to low outdoor temperature and high humidity. Please wait. Water or steam may come from the outdoor unit during defrosting.
Why is air not blowing out during dehumidification operation in my GIWEE COU-D18HR4-A01-S40 Air Conditioner?
If your GIWEE Air Conditioner doesn't blow air during dehumidification, the indoor fan might stop to prevent moisture evaporation and save energy.
How to restart GIWEE Air Conditioner immediately after shut down?
To protect the unit, there is a 3-minute delay before a GIWEE Air Conditioner can restart after being shut down, indicated by the RUN lamp being ON. This protection timer activates automatically when power is connected.
Guidance on safe installation by authorized personnel to prevent hazards like electric shock or fire.
Precautions for safe cleaning, avoiding excessive water and combustible agents, and proper unit care.
Details on compressor delay start, discharge temp shutoff, inverter protection, and compressor preheating.
Comprehensive list of error codes for indoor and outdoor units, detailing malfunctions and their codes.
Detailed steps for diagnosing and resolving specific indoor unit errors like communication failure and sensor faults.
General| Refrigerant | R410A |
|---|---|
| Power Supply | 220V/50Hz/1Ph |
| Operating Temperature (Cooling) | 18-43 °C |
| Operating Temperature (Heating) | 24 °C |
| Cooling Capacity | 18000 BTU/h |
| Heating Capacity | 18000 BTU/h |
To Next Page
