Installation
4
1
Installing the spout assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□ Shut off the water supply. Remove the old
faucet.
2
Installing the faucet assembly
□ Mount the faucet (A) to the laundry sink. The two
mounting tabs should face the front of the laundry
tub, the single tab should face the rear of the basin.
□ Clean the mounting surface.
□ Tighten the mounting screw (B) from the single
tab to secure the faucet (A) into place.
□ Thread the spout assembly (C) onto the faucet
body (A) and wrench-tighten the spout
assembly (C) to ensure a tight seal.
B
A
C
A
To Next Page
Loading...
Need help?
General
