J
jerrymilesJul 25, 2025
What to do if the sensor is not activating the water flow on my Glacier Bay Kitchen & Bath Fixture?
- DDaniel HallJul 25, 2025
If the sensor on your Glacier Bay Kitchen & Bath Fixture isn't activating the water flow, it could be due to a damaged control box. In this case, you should call Glacier Bay customer service to request a replacement control box and replace the old one with the new one. Alternatively, the washer in the 'in' end of the control box might be dirty or damaged. To resolve this, remove the hose and unscrew the connector, then take out the washer from the control box. Clear or replace the washer, and reassemble the connector and hose.