Gladiator GEARTRACK CHANNEL - Measure Location of Remaining Studs; Mount Remaining Studs; Locate Studs and Electrical

8
Wood Studs and Drywall over Wood Studs
■ Use a stud nder to mark the edges of the studs within
your planned installation area. Be sure to also mark the
locations of electrical wiring.
IMPORTANT: Compare screw length to electrical wiring
locations. Be sure the screw will not pierce electrical
wiring.
1. Locate Studs and Electrical
■ Use this stud as your guide. Measure 16” (40.64 cm) from
the corner and snap a vertical chalk line using a chalk line
with a plumb bob. Snap a chalk line every 16” (40.64 cm)
from this point.
■ Align the center of the stud with the chalk line. Attach the
remaining studs to the wall as you did in steps 1-2.
3. Measure Location of Remaining Studs
4. Mount Remaining Studs
16’’(40.64 cm)
16’’(40.64 cm)
Stud Finder