To Next PageTo Next Page
Need help?Do you have a question about the Gladiator GEARTRACK CHANNEL and is the answer not in the manual?
General| Brand | Gladiator |
|---|---|
| Model | GEARTRACK CHANNEL |
| Category | Racks & Stands |
| Language | English |
Lists required parts and tools for installation of channels and panels.
Locates studs and marks electrical wiring locations for channel installation.
Measures channels based on stud locations for proper mounting.
Cuts channels to the required length, ensuring square cuts.
Drives the first screw through the top slot groove to hold the channel.
Levels the channel and drives a second screw through the bottom slot.
Predrills holes to prevent splitting when driving screws near channel ends.
Drives screws in all remaining slots at stud locations for secure mounting.
Ensures all installed screws are flush with the channel surface.
Repeats the mounting process for subsequent channels.
Details spacing requirements for channels used with different accessories.
Snaps end caps onto each end of the installed GearTrack® Channel.
Measures ceiling sag to determine the lowest point for panel alignment.
Marks the bottom of the wall using a chalk line for panel placement.
Installs the first wooden stud as a guide for GearWall panel installation.
Secures the first stud to the wall with masonry screws every 18 inches.
Measures and marks locations for remaining studs, typically 16 inches apart.
Attaches remaining studs to the wall, aligning them with chalk lines.
Uses a stud finder to locate studs and mark electrical wiring for safety.
Ensures panels are installed with the interlock tongue up and groove down.
Measures panel length based on wall coverage and stud locations.
Cuts panels to the required length, avoiding windows, doors, and outlets.
Places the panel against the wall, aligning with chalk lines.
Drives the first screw through the top slot groove into the stud.
Levels the panel and drives a second screw into the same stud.
Predrills holes to prevent splitting when driving screws near panel ends.
Drives screws in all slots at stud locations to secure the panel.
Repeats installation steps to complete a row of panels.
Continues installing rows of panels until the desired wall coverage is achieved.
Shows recommended configuration for applying trim to interior corners.
Shows recommended configuration for applying trim to exterior corners.
Shows recommended configuration for applying trim to end caps.
Shows how to apply trim around openings like windows, doors, and outlets.
Details the installation steps for the advanced bike storage hook.
Details the installation of fishing pole holders, vertically or horizontally.
Details the installation of the horizontal bike hook.
Details the installation of storage bin holders to support bins.
