Charging the battery:
1. The charging port is located at the rear end of the running
board as shown.
2. Open the protective cap over the charging port
3. Make sure the charging port and charger are dry.
4. Make sure that the Folding E-Scooter is turned off.
5. Connect the charging cable to the charging port.
6. Connect the charging device's mains plug to a suitable wall
socket (220 - 240 V / 50 - 60 Hz).
7. The charging light on the charger will light red when charging.
8. The battery is charged once the charging light changes from
red to green. You should stop charging at this point.
9. Disconnect the charger from the mains and the Folding E-
Scooter.
To Next Page
Loading...
