40
Maintenance and care
• Allow the sunshade to dry when open to prevent the formation of
mould and discolouration.
• A protective sleeve protects the sunshade and will extend its ser-
vice life.
• Only pull the protective sleeve over the dry sunshade when it is dry.
• Clean the protective sleeve and the sunshade cover when needed
with lukewarm water and a sponge.
• Do not use any bleach or sharp objects, to avoid damage to the
cover.
• Check the tightness of all screws from time to time and tighten
them if necessary.
• If the sunshade is located in a highly exposed position, increased
wear and tear must be expected. In such cases we recommend
more intensive care and maintenance.
• In most cases, defective sunshades can be repaired by your SUN-
COMFORT/GLATZ partner. Only use original replacement parts
from SUNCOMFORT/GLATZ.
Disassemble the sunshade if it is not going to be used for a longer
period. WARNING! DANGER OF TIPPING. DANGER OF INJURY CAUSED
BY SUNSHADE TIPPING OVER.
1 Close the sunshade correctly and tie up.
2 Take the sunshade out of the base / of the ground socket and lay it
down.
3 Store the sunshade in a lying position along with all accessories in
a dry place.
Disassembly
To Next Page
Loading...
