GLEANER S67 - Edible Beans

Initial Header & Header Drive Setup
• Variable speed header drive (if equipped) in slowest position for draper
headers and direct cut headers.
• Right-hand pivot drive belt positioned on large countershaft drive
sheave.
• Feed chains (front and rear) should be in high position and fast speed.
• Angle pickup header down so pickup attachment and pickup header
auger can breakup clumps of crop material and more evenly feed the
feed chains and lower wind board accordingly.
Tips
• During day in dry conditions, slow the rotor down; at night when
conditions are damp speed rotor up.
Edible Beans
Initial Combine Setup
Rotor RPM
Concave Setting
Fan Opening Chaffer Opening Sieve Opening Chopper Speed Elevator Boots
190 - 230 0.3” - 0.4” 5 - 7
0.75”
(19 mm)
0.375”
(10 mm)
Fast Solid
• Remove all reverse bars and replace with forward bars and remove
separator knives if installed.
Initial Header & Header Drive Setup
• Cutter Bar - In some crops, the material is direct cut so the header
should be set-up accordingly. In many cases, the crop is windrowed
and the material is harvested from the windrow.
• Variable speed header drive in slowest position.
• Right-hand pivot drive belt positioned on large countershaft drive
sheave and small driven pivot sheave.
Tips
• Optional perforated boot covers on clean grain and tailings elevators
may be used if desired but, can cause cracking in certain conditions.
• Optional slow speed elevator kit may be used if desired. Order Slow
Speed Elevator Kit #71394759 from your dealer.
Additional Combine Setup
• If cracking of beans still occurs, remove all lugs on front accelerator
roll and leave lugs on rear accelerator roll to move crop. Lugs should
be reinstalled immediately for all other crops.
6