gledhill ElectraMate 2000 - 1.2 TECHNICAL DATA

Supplied By www.heating spares.co Tel. 0161 620 6677
Page 6
1.0 DESIGN
1.2 TECHNICAL DATA
LEDOM
072ME
071ME
emuloverotsyramirP sertil 072 071
thgieW
ytpmE*
lluF*
)gk(
59
553
57
542
erusserpcitatsdettimrepmumixaM
erotslamrehT*
tiucricgnitaeH*
retawtohcitsemoD*
)rab(
0.3
0.3
0.5
egnarerusserpgnikroW
erotslamrehT*
tiucricgnitaeH*
retawtohcitsemoD*
)rab(
5.2-5.0
5.2-5.0
0.3-5.1
metsySgnilliFcitamotuA
)rab( *5.1
evlavfeilererusserP tiucricgnitaehdnaerots-
rab0.3taetarepoottesyrotcaf-"½
lessevnoisnapxE
erusserpegrahclessevlaitinI*
)dednemmocer(erusserpegrahcmetsyslaitinI*
emulovlessevnoisnapxE*
ezislessevnoisnapxE*
)rab(
)rab(
)sertil(
)mm(
0.1
0.1
04
055x023
0.1
0.1
52
005x092
atadngisedmetsyS
erutarepmetegrahcerotS*
wolf-tiucricgnitaeH*
nruter-tiucricgnitaeH*
teltuoretawtohcitsemoD*
erusserpegrahcmetsysgnitaehlaitinI*
erusserpgnitarepometsysgnitaehlamroN*
etarwolfretawtohmumixaM*
)C°(
)C°(
)C°(
)C°(
)rab(
)rab(
)nim/l(
ybdetcelesyllacitamotuA(58-55
dnamedhctamotmetsyslortnoc
)ffiratyticirtceledna
28
)mumixam(17
)elbatsujdaresunoN(55
0.1
5.2-0.1
53
rofelbaTnoitceleSledoMees(daolgnitaehngisedmumixaM*
)sliatedrehtruf
)Wk( 5.7 0.5
)llA(spmuP*
evlavgnidnelbtrop-3gnitcafleS*
tatsomrehttaehrevoerotS*
tatsomrehttaehrevoreliobcirtcelE*
)ecivedpupototuafotrap(evlavAC*
)ecivedpupototuafotrap(rotalugererusserP*
yrettabretaeH*
BCPniaM*
BCPkaep-ffO*
05-51SPUsofdnurG
H43-MC-16ximauqA
460TGllihdelG
460TGllihdelG
retneverpwolfkcaB"½C9AC
tinullifmetsys3402BA-KStamilA
rab0.1tatesyrotcaf
retaehenilniWk9llihdelG
551TGllihdelG
951TGllihdelG
snoitcennocepiP
wolfgnitaeH*
nrutergnitaeH*
wolfretawtoH*
ylppussniamretawdloC*
)feilererusserp(epipegrahcsiD*
erots-niarD*
yrettabretaeh-niarD*
hsidnutmorfegrahcsiD*
reppoc-mm22
reppoc-mm22
reppoc-mm22
reppoc-mm22
epipegrahcsidotnireppoc-mm51
hsidnutwoleb
"½
"½
reppoc-mm22
ylppuSyticirtcelE
v032@gnitaRWk*
V032@tnerruclanimoN*
)Wk(
)A(
Wk05.0+sretaehWk0.9(5.9
tiucricyrallixua
3.14
1. The flow rates quoted are based on a 35°C temperature rise and assumes the minimum recommended working pressure and
adequate flow are available at the connection to the appliance.
2. The expansion vessel is separate from the appliance complete with a manual air vent/connector. This must be connected
on site by the installer.
3. The domestic hot water outlet temperature is automatically regulated to approximately 55ºC at the bath flow rate of 18 litres/min
recommended by BS6700. The temperature is not user adjustable.
* Minimum water supply pressure at the connection to the appliance under simultaneous demand conditions. (2.0 bar
recommended)