Glide G2 - Troubleshooting

TROUBLESHOOTING
Problem
When I turn
my EScooter
on
nothing hap
pens
The Throttle
does not work
or switch on,
the vehicle
moves without
acceleration.
The range is
low
The breaks are
not working
properly
Charge light is
off
Battery doesn’t
hold the
charge
1. Break levers
go to deep
2. No breaking
power
1. Needs adjust
ment
2. Brake pads are
dirty or need
replacement
1. No any light
Indications on
the display.
2. Power indica
tion light is on
3. Power indica
tion light is on
and the brake
light is “on”
1. The Throttle
does not return
to stop posi
tion.
1. Check the grip
for damage
2. Check the
Throttle spring.
3. The Throttle
handle if it is
loose
1. Bad connection
between the
charger and the
battery.
2. Charger
doesn’t charge
1. Connections
between the
batteries are not
good
2. Bad battery cell
1. Use a flat head
screwdriver to adjust
the gap between the
rubber handle and the
cover.
2. Readjust the Throttle
spring position. Con
tact the supplier
3. Check Throttle
connections. Contact
the supplier
1. Check the charger
plug position.
2. Replace the charger
1. Check all connec
tions between the
batteries
2. Replace the bad
battery cell
1. Adjust the brake
cable  see instructions
2. Clean brake pads
using sand paper or
replace
1. Check the main
breaker under the
seat if it is on
“ON” position.
2. Check power
Connection and
battery level.
3. Check battery
and motor con
nection
4. Check the
brake levers if
they return to
normal position
5. Battery voltage
is below 42 volts.
1. Flip the breaker lever
on “ON”
2. Fasten connections.
3. Clean and fasten
battery terminal con
nectors.
4. Fasten the motor
connections with the
controller under seat
5. loosen the break. If
there is any corrosion
replace. Contact the
supplier.
6. Charge or replace
battery. Contact the
supplier.
Condition Check
Solution
16
SIDECAR