2. Production Operation
Operating with a PS1 or PS4
If you have purchased a LaserLyte L Series with a 100V/240V to 3.5Volt PS1 or PS4 you will
have the following items:
LaserLyte L Series Laser Module
Power Supply Adaptor
100V/240V to 3. 5Volt PS1 or PS4
Main socket to PS1/PS4 power lead (UK, Euro or US)
Optional Extension Lead (3 & 8 meters are available)
1. Plug the 3 pin connector on the end of the lead from the laser module into the 3 pin con-
nector on the power supply adaptor. Plug the male DC jack on the power supply adaptor into
the DC socket on the PS1/PS4. If you are using more then one laser with the PS4 repeat the
above steps until all the lasers are connected. If you have purchased an extension lead, simply
plug the 3 pin connector on the end of the lead from the laser module into the 3 pin connec-
tor on the extension lead.
2. Connect IEC plug to PS1/PS4 power adaptor.
3. Plug the main plug into a mains socket .
4. Switch on the power supply via key switch (If you have purchased a 3.5V PS1/PS4 tted with
a Key Switch) or switch on at the mains socket.
3. Focus Adjustment &
Manipulating The Pattern
The focus of the laser can be adjusted by using the supplied focus key (as shown in diagram B).
Should you need to adjust the focus please follow the simple instructions below:
1. Remove any line/cross optics from the barrel where tted using the focus key so the laser
projects a dot. Models projecting a line will have one optic, models producing a cross will have
two optics.
2. Insert focus key into laser barrel and align with focus control groves on the focusing lens.
3. Turn the focus key until desired focus is achieved.
4. Replace the line/cross optics if tted. For modules projecting a line rotate the optics to achieve
the desired projection. For modules projecting a cross rotate the rst optics to achieve a line
with a centre dot. Then replace the second optics and rotate this optic to achieve a cross.
The LaserLyte L Series XL models allow the user varies the angle between the crossed line so a
90 degree cross is achieved at any angle of mounting. This is simply done by adjusting the front
lens assembly using the supplied focus key.
To Next Page
Loading...
Need help?
General
