Global 670171 - User Manual

Questions and Answers

K
Kaitlyn KnappJul 28, 2025
Why is there no water flow from my Global Dispenser?
- T
  Timothy SandersJul 28, 2025
  If you're experiencing no water flow from your Global Dispenser, several factors could be responsible. First, check the water connection to ensure it is properly connected. A malfunctioning water valve can also cause this issue, in which case the valve should be replaced. Additionally, the outlet may be blocked, requiring you to unblock or replace the affected part. Finally, excessive water pressure (over 70PSI or 5 bar) can be the cause; fitting a water regulator to the mains supply should resolve this.
P
Patricia WardAug 5, 2025
What to do if there is no chemical suction in my Global 670171?
- K
  Kelsey WilliamsAug 5, 2025
  If your Global Dispenser isn't suctioning chemicals, several factors could be at play. Here's what to check: 1. Ensure you have a minimum of 30PSI running water (2 bar). 2. Inspect the tube for any kinks and re-route if necessary. 3. Verify that the chemical container is not empty and replenish if needed. 4. Check for a blocked foot valve, and clean or replace it. 5. Examine the dilution valve for blockages and clean the part. 6. Confirm the dilution clamp is secure to prevent a loose dilution valve. 7. See if the flood ring in the outlet has moved and replace the outlet tube assembly if needed.
J
John WhiteAug 12, 2025
How to fix a Global Dispenser that will not shut-off?
- A
  Alexander BakerAug 12, 2025
  If your Global Dispenser won't shut off, it could be due to a couple of reasons. First, check if the unit has a lock-on feature activated; if so, push the operating button to deactivate it. Alternatively, a malfunctioning water valve might be the cause, requiring a replacement of the water valve.
R
Ronald McbrideAug 20, 2025
Why is my Global Dispenser dispensing too much chemical?
- E
  Erica FullerAug 20, 2025
  If your Global Dispenser is dispensing too much chemical, it could be due to the dilution pin being on the wrong setting; try changing the ratio. Another potential cause is the chemical stiffening; in this case, lower the chemical below the unit injection point.