“Global Pool Products is committed to engineering and manufacturing world class products in the pool industry”
Global Pool Products
1330 Pigeon Rd
Bad Axe, MI 48413 Information contained in this document is proprietary and confidential to
P: 989-269-5900 - TF: 866-712-0606 Global Pool Products and not to be reproduced without
Fax: 989-269-5902 written consent from Global Pool Products.
www.global-poolproducts.com
Page | 4
POST INSTALLATION CHECKLIST FOR TSUNAMI SLIDE
Installer to review with slide owner upon completion of slide installation.
Examine:
The flume for any apparent cracks or gashes.
The ladder for sharp borders, snags, cracks, or gashes.
All fasteners to make sure none are loose.
The ladder for stability and connection to the flume.
✓ Pool water depth at the base of the slide should be at least 3’ (914 mm) deep.
✓ The height of the slide flume exit above the water should be 20” (508 mm) maximum.
✓ The distance between the slide centerline and the edge of other pool equipment should be at least 3’6”
(1067 mm).
MAINTENANCE INSTRUCTIONS
A. Spray your Tsunami Slide down with water to wash away build up.
B. Be sure that all connection points are tight. If not, tighten anchors as necessary.
C. All polyethylene parts require little maintenance. Hose and wipe to clean.
Examine:
The flume for any apparent cracks or gashes.
All fasteners to make sure none are loose.
The ladder and inner flume for sharp borders, snags, cracks, or gashes.
To Next Page
Loading...
Need help?
General