GLOBBER E-MOTION 6 - Page 11

11
ENGLISH
Problem Possible cause Solution
Scooter will
not run
Battery is not charged
- Battery gauge light
lights up in red in this
case

to 4 hours for recharges.
Wires or connectors
are loose or
unplugged
Check to ensure that the charger is securely plugged into both the wall socket
and the scooter.
Scooter
cannot be
charged right
after riding
Battery has probably
reached the safe
temperature limit
The battery has temperature protection. If you try to charge the scooter just
after riding, the battery pack might be at a high temperature, and it will not
accept charging until 25 minutes later when the battery pack cools down.
Wait and try to charge after this period of time.
Scooter run
time is short
The battery does not
charge completely
- Battery gauge light
lights up in red in this
case

up to 4 hours for recharges. Check to ensure that the charger is securely
plugged into both the wall socket and the scooter.
Make sure that the wall socket is connected to the main power supply.
Battery will not charge
fully
1 - You have been using your scooter for a while. The battery has certainly
lost its capacity.
The average rechargeable battery life is 1 to 2 years depending on scooter

 5°C and
30°C 
2 - Your scooter is new and has low battery autonomy.

your dealer or a Globber representative at contact@globber.com
Scooter
suddenly
stops working

scooters

motor has overload protection to ensure safety. If such a sudden stop of the
scooter occurs, wait about a minute or more before switching the battery on
again.
Wires or connectors
are loose or
unplugged
Check all wires and connectors to make sure they are connected and
secure..
Improper use in wet
environment, which
has led to an electric
short
E-MOTION 6 is not designed for wet, rain, or puddle use.
If your problem arises as a result of such use, please contact your dealer or a
Globber representative at contact@globber.com
Scooter runs
sluggishly
Scooter is overloaded


Be careful not to use your scooter on steep slopes, and do not pull or tow
objects or people.
Avoid overloading the scooter as this will cause premature wear of the
battery and its components.
Unsuitable riding
conditions

ground.