3 - ASSEMBLY
two front wheels while paying attention to the direction of insertion.
T-bar height.
4 - MODE OF OPERATION AND USE
ON/OFF FUNCTION
- To start, push your scooter forward; you will here a «beep» sound; you are now in
“ON” mode.
- Your E4 will turn off automatically after 1 minute of inactivity; you will here a
«beep» sound.
MODE
On the side, there is a switch button showing «1 / 2». This is for switching the
- Mode 1
- Mode 2
- Kick scooter mode
runs out of battery.
START-UP
To engage the motor, 3 actions are necessary.
1.
2.
3. Press the accelerator button on the top of the T-bar.
does not automatically cut the motor, see paragraph STOP regarding the
instructions for stopping the motor permanently.
CHECK SPEED
located at the rear of the scooter (mudguard) and/or use the accelerator / throttle
release the pressure to slow down).
- Once the electric motor is engaged, it will accelerate until reaching the cruising
engages again.
STOP
wait for the scooter to stop safely to get off the platform. At any time you can
motor is not engaged for more than 60 seconds.
5
ENGLISH
To Next Page
Loading...
Need help?
General