7 - MAINTENANCE
•
stresses and wear. The various materials and components may react differently to
•
• Do not change any motorised parts yourself or the warranty will be invalidated.
contact@globber.com
•
low. If it is not used for a long period of time, you are advised to charge it once a
or a Globber representative.
The recommended storage temperature for the battery is between 5°C and 30°C.
• Do not use or place the electric scooter in an environment where the temperature
• Never store the electric scooter in a car during hot weather to avoid any danger of
this.
•
properly by turning the electric scooter upside down and pushing the wheel with
wheel. Carefully push the two bearings out of their seating. If they are chipped or
crushed, buy new ones. If there is no visible damage, oil them. To do so, remove
any traces of grease, mud or dust from the bearing using a paper towel or a cloth
•
develop holes if the scooter is used on rough surfaces too much. This is
regularly and have them changed for better safety.
•
for the maintenance-related changes mentioned in these instructions.
•
regularly. They can become loose after a while in which case they should be
tightened. They can become worn and not tighten properly, in which case they
should be replaced.
8 - DISPOSAL OF END-OF-LIFE APPLIANCE
• The appliance must be disconnected from the mains supply when removing the
battery.
• The battery must be removed from the appliance before the appliance is
discarded.
•
point.
8
ENGLISH
To Next Page
Loading...
