EasyManua.ls Logo

Gloria Prima 8 - Maintenance; Problems with the Device

Gloria Prima 8
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
GB
7.2 Storage >>
figure
/
You may be exposed to hazards that could injure you when handling the
device and the spraying agents. You must therefore store the device and the spraying agents
out of the reach of children.
Empty and clean the device as in Chapter 7.1.
7.3 Maintenance >>
figures
Observe the national regulations concerning occupational safety which apply to the place of
operation as well as the applicable national regulations for operations. An expert inspection must
be performed ideally by the maintenance service of the manufacturer to establish whether
hazard-free operation remains possible. This should be performed in the event of defects that
may impair safety in particular, and must be performed at least every 5 years in any case.
Only use original GLORIA spare parts for repairs.
(see GLORIA spare parts shop https://shop.gloriagarten.de).
Repairs must only be carried out by a GLORIA service point.
Further accessories can be found at www.gloriagarten.de
8 Problems with the device
9 Disposal & Legislation
9.1 Environmental protection & disposal of the device >>
The device must be sep-
arated according to the different materials and disposed of at a recycling collection point. The
materials can be recycled according to their designations.
Please check with your local government to find the appropriate disposal point.
Empty the device before disposal and render it unusable.
9.2
Disposal of packaging
>>
The packaging materials have been selected according to
environment ally- suitable and disposal-related aspects and are therefore recyclable.
24
20
23
21
CAUTION
NOTE!
Fault Cause Remedy
Device is leaking at the
screw connection
Hose loose
Tighten coupling nut
and carry out pressure
test with water
Spray pattern of
nozzle not OK
Nozzle partially blocked
Filter in quick closure valve
contaminated
Clean filter or nozzle
Pump does not build
up any pressure
Collar on piston is
worn
Replace collar
RZ_prima 8_980042-00.qxp_Text_GB_prima 8 16.06.17 14:13 Seite 20

Related product manuals