l
ATTENTION!
We hereby explicitly state that we have no li-
ability whatsoever under the German Prod-
uct Liability Law for any damage caused as a
result of unauthorised repairs or by the use of
replacement parts that were not original
GLORIA spare parts, and where the repair
work was not done by our after-sales service
section or an authorised technician. This also
applies to accessory parts.
Equipment
l P
ush button
(A)
l
Valve body complete
(B)
l
Flat spray nozzle
(C)
l
Pump pipe
(D)
l
Pump O-ring
(E)
l
Safety valve
Intended Use
l The industrial device Pro100 is intended for
the application of low-viscous oils and media
containing oil as long as the substances in
question do not attack the device materials.
The maximum temperature is + 40°C.
DANGER!
Danger of life from fire and/or explosion
!
Danger to life if the device is not used as in-
tended! For this reason, observe the following
safety instructions:
l Fine droplets are produced when liquids
are being sprayed. You should therefore
wear suitable protective clothing, includ-
ing protective gloves and respiratory
protection, when handling hazardous
substances.
If atomising inflammable liquids (only
permissible if they have a flash point
above + 55°C!), avoid any sources of igni-
tion in the vicinity and ensure that the
work place is well ventilated.
l Inflammable media may not be applied
with this device.
WARNING
!
Danger to health through contact with
the liquid!
Liquid can cause some damage to health if in-
haled, swallowed or absorbed by the skin.
If
symptoms occur, or in case of doubt, consult
a doctor. Consult a doctor
if you develop symptoms or are unsure.
For this reason, observe the following
safety instructions:
-Note safety instructions on the labels of the
liquids used. Certain liquids require the use
of protective glasses, gloves or other safety
measures.
-
Always request a safety data sheet as per
EWG 91/155 from the manufacturer of the
medium to be sprayed and comply with
instructions.
To Next Page
Loading...
