Foreseeable misuse
l The device is
not
suitablefor:
- acids and alkalis in any concentration.
- fuels.
- wetting agents (surfactants) that cause
or could promote the formation of cracks
in the plastics used.
- liquids at temperatures over + 40°C.
- inflammable liquids with a flash point
below + 55°C.
- very tenacious or sticky liquids, or liquids
that leave residues, which cannot be
completely poured or flushed out of the
unit.
l
On request, the manufacturer of the unit
can make available a detailed list of the
materials used in the parts of the unit for
more detailed examination.
l
Unauthorised changes to the unit made by
the user or inappropriate use shall render
null and void the liability of the manufac-
turer for any damage caused as a result.
Getting Started
l
Unscrew the valve body (B) by rotating to
the left out of the container for filling.
l
Fill the tank, see ”Max. filling volume” in
the Technical data section and the tank
scale for details on the maximum amount
that can be put in.
WARNING
!
Danger to health due to escaping
liquids!
A leaking device or device components can
lead to the liquid escaping or spraying out. For
this reason, observe the following safety
instructions:
-
Check that the unit is in perfect condition
and properly sealed each time before use.
The safety valve must trigger at 3 bar
(approx. 20 pump strokes with 1l fill
volume).
- Only operate or move device when standing
upright.
- Inspect all screw joints for tight fitting.
To Next Page
Loading...
