Supplied By www.heating spares.co Tel. 0161 620 6677
6
www.glow-worm.co.uk
Description
These boilers are designed for use as part of a sealed water central
heating system with fully pumped circulation. The pump, expansion
vessel and associated safety devices are all fitted within the boiler.
Once the controls are set the boiler operates automatically.
Compartment or Cupboard Installations
Ventilation is not required for compartment or cupboard installations.
Do not use the compartment or cupboard for storage.
The minimum clearances to fixtures are shown in diagram 1.
Pluming from flue terminal
Like all condensing boilers it will produce a plume of condensation
from the flue terminal in cool weather. This is due to the high
efficiency and hence low flue gas temperature of the boiler. It is
normal and not a fault indication.
Electrical Supply Failure
The boiler will not work without an electrical supply and normal
operation of the boiler should resume when the electrical supply is
restored.
If the boiler does not resume normal operation, check the external
controls, it may be necessary, to "reset" the boiler, refer to the
following section, "Boiler Safety Devices".
Boiler Design
Diagram 1
*
A removable compartment door can be placed a mini-
mum of 15mm in front of the appliance but there must be
a clearance of 600mm minimum from a fixed surface.
051
5
5050
200
006
To Next Page
Loading...
