Glow-worm Climapro2 RF - 11 Control; Commissioning; 12 User Information; Radio

0020094586_01-08/10-Glow-worm
- 15 -
INSTALLATION
 
 
Establishtheconnectionbetweentheradio
receiverandtheroomthermostat.
Testthequalityoftheradiosignal
(thermostatandwirelessoutdoorsensor).
 
Thisfunctionletsyouperformthepairingbetweenthe
thermostatandtheradioreceiver.
• Fromtheinstallermenu(seeaccesstotheinstallermenu)>
selectonthescreen>>
 
Thisfunctionletsyoutestthequalityofthesignalbetweenthe
roomthermostatandtheradioreceiver.
Inthecasewhereawirelessoutdoorsensorisincludedin
theheatingsystem,theroomthermostatwillalsoindicatethe
qualityofthesignalbetweentheoutdoorsensorandtheradio
receiver.
Wait about fteen minutes after activating the
thermostat and the outdoor sensor before testing.
 
Excellent
Normalfunctioning
Average
Poor Operatinglimit*
Null Inoperative*
(*) Check the room thermostat’s batteries (see the
instructions). If the signal quality does not improve.
Change the location of the appliances, reducing
distances and removing obstacles.
• Fromtheinstallermenu(seeaccesstotheinstallermenu)>
selectonthescreen>>
 
Afterinstallingtheroomthermostat:
• Turnontheapplianceaccordingtotheoperatinginstructions
andcheckforcorrectoperation.
 
Attheendoftheinstallation:
- explaintheoperationoftheapplianceanditssafetydevices
totheuser,ifnecessaryprovideademonstrationandanswer
anyquestions;
- givetheuseralltherequireddocumentation,
- llinthedocumentswherenecessary;
- advisetheuseroftheprecautionsnecessarytoprevent
damagetothesystem,applianceandthebuilding;
- remindtheusertoservicetheapplianceannually.