Connect Hose to Glowforge Air Filter
Put the other clamp around the other end of the hose. Repeat the procedure above to
attach the exhaust hose to the top of the Glowforge Air Filter with the ring clamp.
Keep the hose as straight as you can, with no more than three turns of 90 degrees or less.
Make sure the hose isn’t twisted, pinched, kinked, punctured, or flattened. If there is extra
hose, do not let it sag; wrap it tightly with duct tape to keep the hose length as short as
possible.
Copyright Glowforge, Inc. 2020 13
To Next Page
Loading...