If the mirror is unblemished, replace it carefully
● Replacing the mirror incorrectly can permanently damage your Glowforge. Fortunately,
we designed it to be easy!
● Hold the mirror by the handle and gently
slide it into the notch with the mirror at
a 45 degree angle to the top of the
Printer Head.
Set the mirror gently back into the notch so that
the Glowforge logo on the handle faces up and
is parallel to the floor. It will rest softly in place -
there is no need to push it in.
The mirror handle should look like this:
Tap the blue handle once. This will help ensure
that the mirror is resting properly in place.
Replace the top of the printer head.
Copyright Glowforge, Inc. 2020 46
To Next Page
Loading...