German Light Products GmbH
Instruction Manual 5
5 and 30 flashes per second, may cause seizures in persons with photosensitive
epilepsy. Check local regulations on use of strobe lighting and notify the public in
advance when strobe effects are used. If a seizure occurs, stop using strobe effects.
Help the person sit in a safe place or lay them on their side with their head supported
to prevent it from hitting the floor. Do not use force. Seek emergency medical help if
the seizure lasts for more than a few minutes.
Do not operate a fixture with damaged, cracked, or missing pieces. All optical
components and covers must be in good condition to prevent injury from UV
radiation.
The lamp contains mercury. Do not attempt to clean or repair damage from a
broken lamp. Special safety precautions must be taken. Refer the fixture to an
authorized service facility.
The fixture is heavy. When handling, use a two-person lift to prevent injury.
1.4 NOTICE! Prevent Damage to Product or other Property
Avoid pointing the front of the fixture towards direct sunlight
or other strong light sources. The front lens focuses and
concentrates light just like a magnifying glass. Direct
sunlight and other bright light sources can cause internal
damage to the fixture, melting components or starting an
internal fire within seconds.
Damage can occur whether the fixture is powered on or off. To avoid problems:
Never expose the front of a fixture to direct sunlight or any other strong light sources.
For outdoor applications during daylight, make sure that the front face of any fixture
is shielded or points away from the sun, even when not in use.
Avoid pointing other high-powered beam lights directly at the fixture.
Ensure that the moving head can rotate through its full range of motion before
powering up the fixture, and that fans and air vents are clean and unobstructed.
Do not pick up or carry the fixture by the front lens bezel. The LCD display is also
fragile. Picking up or supporting the fixture in these spots could result in damage
that is not be covered by the warranty.
Use only original spare parts. Any structural modification on the system will terminate
all warranty claims.
Do not exceed 1500 lamp hours. Risk of damage from lamp explosion increases as
the lamp approaches its specified usage life. For best performance, replace the
lamp after 1000 hours of operation.
Clean optical components only as directed. Oils, solvents, and other chemicals
commonly used for cleaning can damage the lens coatings and surfaces.
To Next Page
Loading...
