Gmax FF49 - User Manual

Shield Removal and Installation
Models
• GM49Y
• FF49
• FF88
• GM64
• GM54
• OF77
• GM67
Outer Shield lens Removal
1. Raise the outer shield into the fully raised position.
2. Locate the side ratchet plates that secure the shield to the helmet.
3. Push down on the pin that locks the ratchet plate retaining arm into the secure position.
4. As you push down on the pin, move the retaining arm on the ratchet plate on the open
position. The shield will release from the ratchet plate when the retaining arm is in the open
position.
To install the outer shield: reverse the removal process.
Models
• GM11
Outer Shield lens Removal
1. Remove the two side screws that secure the visor to the helmet.
2. Rotate the lever to release and remove the shield.
3. With the shield in the fully closed position, reinstall the visor and screws.
To install the outer shield: reverse the removal process.

Gmax FF49 Specifications