Installation Instructions
The following instructions explain how to install and
remove your vehicle’s winter cover. When installing or
removing the cover please refer to the “Usage
Guidelines” mentioned previously. When you first try to
fit the cover it may appear to be undersized. This is
due to the nature of the special vinyl, which will stretch
during installation to insure a tight fit. For this reason,
the initial installation of the cover is best performed when
the winter cover is warm. If you are required to use a
front license plate, simply cut the black stitches on
the back of the patch.
Grille Cover Installation
1. Pre-bend all the small black tabs into the shape
ofaJ.
2. Remove the four push pins and slide them through
each of the pre-punched tabs.
3. Install the four push pins into the grille.
4. Hook all the tabs to the edge of the grille.
5. Fasten the snaps.
Lower Cover Installation
1. Pre-bend all of the small black tabs into the shape
ofaJ.
2. Fasten each tab to
edge of the bumper,
as illustrated.
To remove the winter cover reverse the steps listed
previously.
Engine Coolant Heater
In very cold weather, 0°F (18°C) or colder, the engine
coolant heater can help. You’ll get easier starting
and better fuel economy during engine warm-up.
Usually, the coolant heater should be plugged in a
minimum of four hours prior to starting your vehicle.
2-7
To Next Page
Loading...
