General inspection
1. Regularly check that all the fixing screws are tight.
2. The supply cord of the tool should be checked
frequently for damage. If damaged, have the cordset
replaced by an authorised service facility to avoid a
hazard.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all
times.
2. Remove dust and dirt regularly. Cleaning is best done
with a soft brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. If the body of the compressor needs cleaning, wipe it
with a soft damp cloth. A mild detergent can be used
but nothing like alcohol, petrol or other cleaning agent.
5. Never use caustic agents to clean plastic parts.
Caution. Water must never come into contact with the
tool
Repairs
1. Only an authorised service centre should replace the
cordset or carry out other repairs. If the cordset is
damaged or worn, have it repaired or replaced by an
authorised service centre.
15
To Next Page
Loading...
