3. Tighten the lower anchor attachments and the
top tether. The child restraint instructions will
show you how.
4. Push and pull the child restraint in different
directions to be sure it is secure.
Front Seat — Regular/Extended Cab
without Rear Seats
Your vehicle has a right front passenger’s airbag
and a passenger sensing system. The passenger
sensing system is designed to turn off the right
front passenger’s frontal airbag when an infant in
a rear-facing infant seat or a small child in a
forward-facing child restraint or booster seat is
detected. See Securing a Child Restraint in
the Right Front Seat Position on page 71 and
Passenger Sensing System on page 86 for
important safety information and additional
information on installing a child restraint in the
right front seat position.
1. See Securing a Child Restraint in the Right
Front Seat Position on page 71 for instructions
on installing the child restraint using the
safety belts.
2. If the child restraint manufacturer’s instructions
recommends that the top tether be attached,
attach and tighten the top tether to the top
tether anchor. Refer to the child restraint
instructions and the following steps:
2.1. Pull the seatback forward to access the
top tether anchor. See Seatback
Latches on page 16.
2.2. Pull on the finger access tab to remove
the cover to access the top tether
anchor.
2.3. Route the top tether according to your
child restraint instructions and the
following instructions:
If the position you
are using has a fixed
head restraint and
you are using a single
tether, route the
tether over the head
restraint.
67
To Next Page
Loading...
