oSEEK p: The tape must have at least
three seconds of silence between each selection
for seek to work. The left arrow is the same as the
PREV pushbutton and the right arrow is the same
as the NEXT pushbutton. If either arrow is held or
pressed more than once, the player continues
moving backward or forward through the tape.
AM FM: Press this button to listen to the radio
when a tape is playing. The inactive tape remains
safely inside the radio for future listening.
TAPE: Press this button to play a cassette tape
when listening to the radio. CAS appears on
the display when a tape is loaded.
Z(Eject): Press this button to eject a tape.
Eject may be activated with the radio off. Cassette
tapes can be loaded with the ignition and radio
off if this button is pressed first.
Cassette Tape Messages
ERR (Error): If the player detects a tight or
broken tape, this message appears on the display
and the player ejects the tape. The radio goes
back to playing the last station selected.
CLN (Clean): If this message appears on the
display, the cassette tape player needs to
be cleaned. It still plays tapes, but it should be
cleaned as soon as possible to prevent damage to
the tapes and player. See Care of the Cassette
Tape Player on page 198.
If the cassette is not playing correctly, for any
other reason, try a known good cassette.
If any error occurs repeatedly or if an error cannot
be corrected, contact your dealer. If the radio
displays an error message, write it down and
provide it to your dealer when reporting the
problem.
191
To Next Page