GNATUS CD-4810 - Cleaning Methods: Advanced Cleaning; Cleaning Methods: Special Cleaning

16
Advanced cleaning
Special cleaning
Appropriate places: Automotive repair and
hardware manufacturers stores.
Cleaning methods:
5. Press the SET button to set the clock to 10 minutes. Press the On/Off button once
to start cleaning. The fat will be dissipated and will appear to be something as a black
smoke on the water.
6. Replace the water and wash the objects for an additional 3 minutes to remove the
debris.
1. Place the objects directly in the cleaning
tank.
Do not place objects over each other, to avoid
friction during cleaning.
2. Add water to a level between MIN and MAX
above the objects.
3. Press TC to turn the heater on , it will
ash.
To cancel the heating, press TC again when the
water temperature reaches 40ºC after about 20
minutes.
Appropriate places: Manufacturers of
products made of copper, silver or bronze.
Cleaning methods:
1. Place the objects in the basket and then in the
tank; add water to a level between MIN and MAX
above the objects.
2. Press TC to turn on the heater , it will
ash. The water temperature will reach 50ºC
after 30 minutes. ( it turns off after the set
temperature is reached.)
3. Press the SET button to set the clock to 15
minutes.
4. Press the Function button to select the
degassing function. It will light up .
Press the On/Off button to start the degassing.
After 90 seconds, the device will automatically
switch to normal cleaning mode.
EQUIPMENT’S OPERATION
Cleaning methods