5
5. Gently set the Link into place, tucking the cables into the opening.
6. Using the provided four screws, secure the Link into place.
7. Using the 8mm port, plug the power source into the Link.
Black Cable (-)
-
Red Cable (+)
Blue Connector
Data Transfer
Connector
+
Ensure cable is fully inserted and tightly in place before use. Check
upon subsequent uses. For questions, contact Solutions Center at
support@goalzero.com or 1-888-794-6250
WARNING: Do not exceed 22V input for the module. Doing
so can cause serious damage to the Yeti and potential bodily
injury. Take note of voltages when using third party solar panels
with the module. Do not chain solar panels in series (positive
to negative, positive to negative, etc.), as this can result in
dangerously high voltages.
To Next Page
Loading...