8
Replacing the attachments
When changing the attachments ensure
the stick vac is switched off.
The floor head and crevice/brush multi-
tool can fit directly onto the main body
for close up vacuuming and low level
dusting and cleaning. For high level
cleaning the crevice/brush multi-tool can
fit on the end of the extension pole.
1. To use the stick vac more as a
handheld vac, remove the extension
pole and replace with the floor head.
Press the release clip on the top of
the extension pole (1) and pull the
extension pole away from the main
body (2).
2. Remove the floor head from the
extension pole in the same way
by pressing the release clip on the
floor head and pulling away the
extension pole.
4. Turn the stick vac on by pushing the
power on/off switch downwards.
5. Move the floor head back and forth
over the surface. Use even strokes.
Don’t press hard; allow the floor head
to suck away the debris.
6. When finished turn off the power on
the vac and to the mains supply.
Note: Lean the stick vac safely against a
wall or surface, or lay the vac down on
the floor when not in use.
1
2
To Next Page
Loading...
