Gocycle
®
Owner’s Manual for GS, August 2018
© Karbon Kinetics Limited. All Rights Reserved. 36
2. Inspection of disc covers for damage (Front and Rear)
3. Hub Cap in position to prevent excessive dust contaminating Hub Gear
4. All Cleandrive magform bolts present x 12, 4-6Nm (one located at front of Cleandrive - check
by folding)
5. Pivot block magform bolts present x 5, 4-6Nm
6. Check pedals are tight, 35-40Nm
7. Check crank bolts are tight, 35-40Nm
8. Not Applicable for GS Models
9. Ensure quick release lever is correctly adjusted and closes with increasing force to keep
handlebar clamped
10. Check steam adjuster bolts and top hats are present and tight, 7-8Nm
11. Check that headset is not loose. (Section 6.12 for adjustment.)
12. Check Cam Lever free play of all three cam levers on both wheels when fitted to the
respective hubs (Section 6.8 for adjustment)
13. Check cam cover bolts are all present and torqued to 0.8Nm
14. Check hub gear for excessive movement – (conducted after confirming all cam levers are
adjusted correctly) (Section 6.14 for adjustment)
15. Check both brakes are operating correctly and levers cannot be pulled to the bar
16. Ensure Gocycle Firmware is up to date. Go to Settings in your GocycleConnect App and
scroll down to Firmware.
WARNING! Should you discover a fatigue crack more than 3mm long, or should you suspect that a
component may have received an impact in an unusual way—such as if the product has been
dropped—do not ride your Gocycle and immediately contact techsupport@gocycle.com.
To Next Page
Loading...
