Gocycle GS - 4.5 Assembling the Seatpost Tool Holder

Gocycle
®
Owner’s Manual for GS, August 2018
© Karbon Kinetics Limited. All Rights Reserved. 16
4.5 Assembling the Seatpost Tool Holder
Orientate the Tool Holder as
shown
Locate the Snap Rail Tool Holder
above the saddle rails as shown.
Apply pressure onto the right
hand side of the Snap Rail Tool
Holder until this side is properly
located onto the right saddle rail.
Apply pressure onto the left
hand side of the Snap Rail Tool
Holder until this side is properly
located onto the left saddle rail.
Confirm both sides of the Snap
Rail Tool Holder are properly
located onto the saddle rails.