Gocycle
®
Owner’s Manual for GS, August 2018
© Karbon Kinetics Limited. All Rights Reserved. 63
Open the QR Lever to 90
degrees and slowly rotate
the clock nut until it stops
against the handlebar stem
lower. Rotate so that one of
the holes in the clock nut
aligns with the hole in the
stem lower to allow the
securing bolt to be refitted.
The QR should have roughly
120 degrees of free play
before it beings to engage.
The closing resistance
should act over the
remaining 60 degrees of
movement till it is firmly
shut in the correct location.
If it is too loose, rotate the
clock-nut clockwise till the
next hole aligns with the
hole in the stem lower and
recheck
Conversely if it is too tight
rotate the clock-nut
anticlockwise to the next
hole and recheck.
To Next Page
Loading...
