Wireless Multiple Flash Shooting
● Auto Shooting with Two Receiver Groups
You can divide the Receiver units into two or three groups and perform TTL
autoflash while changing the flash ratio (factor). In addition, you can set and
shoot with a different flash mode for each firing group, for up to 5 groups.
● Auto Shooting with Three Receiver Groups
When using the AD100Pro and Godox X2 series trigger together，the X2 can
control the flash function such as:
• Flash Mode: TTL, M, Multi • Sync Mode: First-curtain sync, second-curtain sync
and High-speed sync • Control the power level • Modeling Lamp turn on or off
• Beeper turn on or off2
A
B
A
B
C
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless base station, 2.4G
wifi router, Bluetooth, etc.)
→ To adjust the channel CH setting on the flash trigger (add 10+ channels) and use the
channel which is not disturbed. Or turn off the other 2.4G equipment in working.
2. Please make sure that whether the flash has finished its recycle or caught up
with the continuous shooting speed or not(the flash ready indicator is lighten)
and the flash is not under the state of over-heat protection or other abnormal
situation.
→ Please downgrade the flash power output. If the flash is in TTL mode, please try to
change it to M mode(a preflash is needed in TTL mode).
3. Whether the distance between the flash trigger and the flash is too close or not
→ Please turn on the “close distance wireless mode” on the flash trigger (＜0.5m):
X2 & X1 series: press the test button and hold on, then turning it on until the flash
ready indicator blinks for 2 times.
XPro series: Set the C.Fn-DIST to 0-30m.
4. Whether the flash trigger and the receiver end equipment are in the low battery
states or not
→Please replace the battery(the flash trigger is recommended to use 1.5V disposable
alkaline battery).
The Reason & Solution of Not Triggering in Godox 2.4G Wireless
- 39 - - 40 -
To Next Page
Loading...
