1211
Technical Data
● Slave Trigger Model
The flash will be fired synchronously with one external flash. This
model can act as an auxiliary lamp, offering various effects of light and
shadow.
● Tube Replacement
Turn down the power before replacing the flash tube and wear insulated
gloves. Then, loosen the iron wire on the tube, keep a balanced hold on
the two feet of the flash tube and pull out the old tube gently. Take down
the feet casing to put it on the new one. Hold two feet of the new tube,
and target directly towards the two copper outlets, then push them slightly
in. Tighten the iron wire to fix the flash tube.
Flash Output 150WS 180WS
Guide Number (m ISO 100) 42 45
Color Temperature 5600±200K
Power Voltage
AC220/60Hz or 100V/60Hz
Flash Power Control stepless
Modeling Lamp
75WS
Recharging Time 0.5 -3 sec
Flash Triggering Method Sync cord, Test button, Slave
Flash Duration 1/2000-1/800s
Fuse 5A
Dimension 190*150*105mm
Weight Ａｐｐｒｏｘ 0.59KG
● Shut down the device immediately when it works abnormally and
find out the reason.
● Avoid sudden impacts and the lamp should be dedusted usually.
● It’s normal for lamp being warm when in use. Avoid continuous flashes
when it is not necessary.
● Maintenance of all the flashes is up to our authorized maintenance
department which can provide original accessories.
● One year warranty period will be canceled when any unauthorized
maintenance is found.
● If the product had failures or is wetted, it can be continuously used only
after it is repaired by professionals.
● Disconnect the power when doing maintenance work or cleaning.
● New changes made to the specification may not be updated in this
manual.
Maintenance
To Previous Page
Loading...
