- 15 - - 16 -
* Product design and specifications are subject to change without notice.
Technical Data
LED Video Light
Power Supply
Output Power
Color Temperature Range
100% Light Brightness(LUX,1M)
CRI ≈
TLCI ≈
Light Brightness Range
Operation Temperature
Channel
Group
Dimension (not included a
standard reflector)
Net Weight(not include reflector
and protect cover)
SL200IIBi
AC100V-240V(50/60Hz)
200W (Max.)
2800~6500K
≈39200 (Max.)
96
97
0%-100%
-1040
32
16(A, B, C, D, E, F, 0-9)
36.5*20*16cm
≈3.25Kg
Maintenance
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This product, except consumables e.g. cable, is supported with a one-year warranty.
Avoid sudden impacts and the product should be dedusted regularly.
Maintenance of the flash must be performed by our authorized maintenance
department which can provide original accessories.
Unauthorized service will void the warranty.
If the product had failures or was wetted, do not use it until it is repaired
by professionals.
Changes made to the specifications or designs may not be reflected in this manual.