Godox V1N - Page 8

Hz
Maximum Stroboscopic Flashes:
Flash
output
Hz
Flash
output
Wireless Flash Shooting: Radio (2.4G) Transmission
● You can set up five slave groups for TTL autoflash shooting.
With TTL autoflash, you can easily create various lighting effects.
● Any flash settings for the slave units(auto flash, manual flash and
stroboscopic flash) on the master flash in TTL mode will be
automatically sent to the slave units. So the only thing you need to
do is to set the master unit for each slave group without any
operation for the slave units at all during the shooting.
● This flash can work in i-TTL /M /RPT/ OFF flash modes when set
as a master unit.
Note:
● Even with multiple slave units, the X series flash trigger can
control all of them via wireless.
● In this user manual, “master unit” refers to the camera flash
on a camera and “slave unit” will be controlled by the
master unit.
1/4
1/8
1/16
1/32
1/64
1/128
1/256
1
8
14
30
60
90
90
90
2
6
14
30
60
90
90
90
3
4
12
30
60
90
90
90
4
3
10
20
50
80
90
90
5
3
8
20
50
80
90
90
6-7
2
6
20
40
70
90
90
8-9
2
5
10
30
60
80
80
1/4
1/8
1/16
1/32
1/64
1/128
1/256
10
2
4
8
20
50
70
70
20-50
2
4
8
16
30
40
40
60-100
2
4
8
12
20
40
40
Positioning and Operation Range (Example of wireless flash
shooting)
● Autoflash Shooting with One Slave Unit
● Use the supplied mini stand to position the slave unit.
● The transmission distance might be shorter depending on
the conditions such as positioning of slave units, the
surrounding environment and whether conditions.
● Before shooting, perform a test flash and test shooting.
Transmission distance is about 100m.
● Auto Shooting with Two Slave Groups
● Auto Shooting with Three Slave Groups
You can divide the slave units into two or three groups and perform
i-TTL autoflash while changing the flash ratio (factor). In addition,
you can set and shoot with a different flash mode for each firing
group, for up to 5 groups.
Wireless Multiple Flash Shooting
A
B
A
B
C
- 43 -
- 44 -