1. Turn off the camera and mount the flash trigger on camera hot shoe. Then, power on the
flash trigger and the camera.
1. Turn off the camera and mount the flash trigger
on camera hot shoe. Then, power on the flash
trigger and the camera.
2. Slide the screen of X3 down from the top to
display <Setting>, press <Setting> to enter C.Fn.
menu, then press <Wireless> to set CH and ID. Slide
the screen from the left to the right to return to the
main interface, on which you can set the flash
mode and output power level of groups.
2. Slide the screen of X3 down from the top to
display <Setting>, press <Setting> to enter C.Fn.
menu, then press <Wireless> to set CH and ID. Slide
the screen from the left to the right to return to the
main interface, on which you can set the flash mode
and output power level of groups.
3. Turn on the retro camera flash Lux Master, press
the MENU button to enter the main interface, turn
the adjust dial to wireless then press the set button
to enter wireless interface.
A：Slide the screen to select CH, GR or ID setting,
press to enter a certain setting, then slide to set the
parameters. Please set the channels and IDs of the
flash and X3 to the same.
B：Press the “Wireless Sync” of the flash trigger and
wireless sync icon of Lux Master can set the
channels and IDs of them to the same.
4. Press the camera shutter to trigger.
SCAN
Wireless Sync
CH ID
49 50
To Next Page
Loading...
