Troubleshooting
1. Unable to trigger a flash by pressing Test Button or the
camera's shutter-release button.
• Make sure batteries are installed properly and the trigger set
is powered on.
• Check if the transmitter and the receiver are set to the same
channel. If not, set to the same position.
• Check if the trigger set is securely seated into the camera's
hot shoe.
2. Signal disturbance or shooting interference.
• Change a different channel on the trigger set.
3. Short workable distance or flash missing.
• Check if batteries are exhausted. If so, replace with new
batteries.
Maintenance
1. Avoid sudden drops. The device may malfunction after
strong shocks or impacts.
2.
Keep dry. The device is not water-proof. Malfunction, rust,
and corrosion may occur and the device may go beyond
repair if immersed in water or expose to high humidity.
3.
Avoid sudden temperature changes. Condensation may
happen if the ambient temperature changes suddenly, for
example, in a case when the trigger set is taken out of a
build with a high temperature to outside in winter. Please put
the trigger set in a handbag or plastic bag beforehand.
4.
Keep away from strong magnetic field. The strong static
or magnetic field produced by devices such as ratio
transmitters leads to malfunction.
To Previous Page
Loading...
