Goes Cobalt - Maintenance & Lubrication

-101-
There is a check hose at the bottom of the air filter case.①
If dust or water collects in this hose, empty the hose and clean
the air filter element and air filter case. If there's a lot for water,
please contact your local dealer to check if any water inside
crankcase
.
1. Remove seat and disassemble cover of air filter.
2. Remove spring ① and remove upper cover of air filter ②.
3．Remove bolt of pipe clamp③.
4. Remove air filter element ④.
5．Remove polyurethane foam of filter element，
Wash the air filter element gently but thoroughly in solvent.
Squeeze the excess solvent out of the air filter element and
let it dry.
6. Softly clean dust on filter element.
7. If necessary, use new filter element to replace.
CAUTION
Don't use liquid to wash paper filter element.
8. Inspect the air filter element and replace it if damaged.
9. Install air filter element and connect to hose.
10. Install the air filter case cover and be sure to seal ring installed well.
Maintenance & Lubrication
④③
②
①