In case there is a failure, EPS indicator starts to flash. Do NOT switch off the machine. Check the
flash times of EPS indicator. Write down the flash patterns and then refer to the Trouble Code Table
for diagnosis.
Each trouble code consists of 2 digits,denoted by the times of long flash and short flash of EPS
indicator.
Times of long flash represent the tens digit;
Times of short flash represent the single digit;
Duration of long flash: 2 sec.
Duration of short flash: 1 sec.
Flash interval: 1 sec.
The flash cycle will repeat after EPS indicator turns off for 3 seconds.
In case of an EPS failure, do not disassemble the EPS system.
Check the wiring for any loosening
connection. Otherwise
please contact an authorized dealer for service.
NOTE
①
②
-142-
EPS indicator on the Dashboard will be on when EPS system ① is equipped to the vehicle. Normally,
EPS fault alarm indicator on dashboard will be on when EPS breaks down.
②
To Next Page
Loading...