GOGpaintball.com
QUICK START
01 02
03
Unpack the Envy
TM
and its barrel. Screw the barrel into the front of the
marker, hand tight. Take care not to strip the barrel threads or over-
tighten.
Put the supplied barrel
blocker over the end of the
barrel, securing its cord as far
back on the Envy
TM
body as
possible, and cinching it tight.
Fill the loader with paintballs. If it is a powered loader, turn it on. While wearing ASTM compliant paintball goggles, in an area where all bystanders are protected, remove the barrel
blocker and re over a chronograph to measure the velocity. Using a 5/32-inch allen wrench on the adjuster in the bottom of the vertical regulator, turn clockwise to increase the
velocity/pressure, and counter-clockwise to decrease. Take three or four shots after every adjustment to allow the gas pressure inside the Envy
TM
to stabilize. Adjust until the marker
is ring consistently within the limits for the eld where you are playing (for safety reasons, never adjust the Envy
TM
to re at greater than 300 feet per second). Depending on what
modes of re are allowed at the eld where you are playing (semi-automatic, rebound, etc.) you may need to adjust the Envy
TM
’s ring mode. See the Electronic Adjustment section
for more information.
Fit a paintball loader into the feedbeck
of the Envy
TM
. Use a 7/64-inch allen
wrench to lock the loader in place.
Powered force-feed loaders are
recommended, as the Envy
TM
has
little recoil, and can easily outpace an
unpowered or agitating loader.
Gently gas up the Envy
TM
by
slowly turning on the air system
or screwing the CO
2
or screw-
in style HPA system into the
bottom-line ASA.
A gentle rise in pressure
is important, as a sudden
blast may reduce the service
life of the Envy
®
’s internal
components.
Turn on the Envy
TM
by
pressing the power button
momentarily.
Although the power button
serves as the Envy
TM
’s safety
switch to prevent accidental
ring, it should never be relied
upon in place of a barrel blocker
and proper eye protection.
04 05 06
BARREL BARREL BLOCKER FILL TANK
LOADER TURN ON GAS TURN ON THE ENVY
TM
ADJUST VELOCITY
Have your compressed air
(HPA) or CO
2
tank lled by
a person who is properly
trained to do so. If using an
HPA system with an on/off
valve, make sure it is in the
OFF position. If using a CO
2
tank or screw-in style preset
HPA system, ll it while it is
removed from the marker.
07
00
To Next Page
Loading...