GOG Envy - Barrel Blocker; Hopper

GOGpaintball.com
FIG. 1
FIG. 2
BARREL BLOCKER IN USE
USE HIGH PERFORMANCE LOADER
The Barrel Blocking Device is a critical piece of paintball safety equipment - nearly as important as
paintball goggles. The Barrel Blocker serves to protect against accidental discharge of a paintball by
catching it before it can cause harm. A Barrel Blocker is included with the Envy
TM
and must be used every
time it is handled in an area where people or property are not properly protected by paintball goggles or
paintball eld netting. To use the Barrel Blocker simply slip it over the end of the barrel and stretch its
cord back over the back of the Envy
TM
or the rearmost part over which it can be securely looped. Use
the strap’s adjuster to cinch the strap tight, so that the Barrel Blocker can provide protection against
accidental discharge of a paintball.
The Barrel Blocker should only be removed when the Envy
TM
is on a “live” paintball eld and all persons
involved are wearing proper paintball protection.
The Envy
TM
is a high performance tournament grade paintball marker. Its low-force bolt will often prevent
paintballs from being chopped if the hopper is not able to load paintballs as fast as the Envy
TM
is
being red. If you want to realize the Envy
TM
’s maximum repower potential, especially if it is upgraded
with a circuit board that utilizes an anti-chop eye for higher rates of re, you will need to use a high
performance loader. High performance loaders, especially those which provide force-feeding, will yield
the best results with the Envy
TM
.
The Envy
TM
is equipped with a clamping feedneck that allows it to adapt to the small size differences
in hopper neck sizes, yet lock or release quickly. Using a 7/64-inch allen wrench, loosen the clamping
feedneck before installing a hopper. If the hopper is a tight t, a at bladed screwdriver may be used to
further spread the gap in the feedneck clamp, provided the clamp screw has been loosened enough.
The Envy
TM
may also be congured so that the hopper is located to the right, left, or directly above the
center of the marker. See the Advanced Maintenance Section of this manual for instructions to change
or reposition the feedneck.
BARREL BLOCKER
HOPPER
BARREL BLOCKER/HOPPER
PLEASE READ CAREFULLY
03