GOG Envy - Battery

GOGpaintball.com
OVER TIME BATTERIES MAY LEAK. ALWAYS REMOVE THE
BATTERY FROM THE ENVY
TM
WHEN STORING FOR FOR MORE
THAN A MONTH.
BATTERY
The Envy
TM
is powered by a standard 9-volt alkaline battery. Lower cost “heavy duty” batteries will not
consistently deliver the amperage needed to operate the Envy
TM
. Erratic performance, especially drops in
velocity or skipped shots during rapid re can result from a battery that is not delivering full power.
The Envy
TM
is also compatible with 9-volt rechargeable batteries. Because specications of batteries
vary widely from brand to brand, use of any rechargeable battery will require testing to determine if it
can power the Envy
TM
reliably. Some NiCD “9v” rechargable batteries actually operate at 7.2 volts. These
types of batteries will not work well with the Envy
TM
.
Any time the Envy
TM
exhibits erratic performance, drops velocity or skips shots while rapid ring, does not
shoot or does not turn on, the rst step in troubleshooting should always be to replace the battery with a
brand-new, name-brand alkaline battery.
To replace the Envy
TM
battery, use a 5/64-inch allen wrench to remove the two screws from the left side
of the rubber grip, then open the grip. Remove the old battery, taking care not to bend, kink or strain its
wires. Unsnap the battery from its connector by pulling on the connector, not the wires. Snap in a fresh
battery, then place that in the grip frame, tucking the wires into place, before closing and re-securing the
grip.
FIG. 6
BATTERY
ALKALINE BATTERY
06