Gogen BPS 686 - Bluetooth Operation; Aux-In Operation; Technical Specifications

EN - 28
EN
BLUETOOTH OPERATION
1. Press the FUNCTION button on unit to switch to BLUETOOTH function, the LCD will display
“bt” and the pair indicator will flash at high speed.
2. Turn on the Bluetooth function on the device, scan the unit “GOGEN DANCE” and connect,
then input the password 0000 if required, the pair indicator keep light up to indicate
connection done, and the display will show “bt”. Press Play to start playback.
3. Rotate the VOLUME knob on the unit or adjust the volume on the external device to
increase or decrease the music volume to your desired level.
4. Press and hold the PLAY/PAUSE/PAIR/SCAN button to disconnect Bluetooth.
Note: The Bluetooth works best within 10 meters in open air.
AUX-IN OPERATION
1. Press the FUNCTION button on unit to select the “AUX” mode.
2. Connect your audio device to the AUX IN jack on the top panel of the unit with an AUX IN
cable.(audio cable is not included)
3. Rotate the VOLUME knob on the unit or adjust the volume on the external device to
increase or decrease the music volume to your desired level.
4. Control the playback with your audio device.
MIC JACK OPERATION
Microphone input is available in all modes.
1. Connect your microphone to the 6.3 mm MIC JACK found on the top panel of the unit.
2. Rotate the MIC VOL. knob on the unit to increase or decrease the microphone volume.
3. Press the ECHO Button to turn on or off the echo effect of the microphone.
TECHNICAL SPECIFICATIONS
GENERAL
Power Requirements AC100-240 V~60/50 Hz
Power consumption 33 W
Power output 2 x 30 W
FM frequency FM 87.5-108 MHz
AUX in jack 3.5 mm
Microphone jack 6.3 mm
Work temperature 5 °C - +40 °C
BLUETOOTH
Communication system Bluetooth Standard version 2.1+EDR
Reception Range 10 meter (line-of-sight distance)
Compatible Bluetooth proles Advanced Audio Distribution Prole (A2DP)
Wireless Working Frequency 2,402 – 2,480 GHz
E.i.r.p. -4,71 dBm
ACCESSORIES
Instruction Manual, AC Cord