Gojo LTX - Securing Module and Cable Connection; Power Activation and System Test

7.
With the antenna wire in place, swing the top of the module
down and snap into place to secure the module.
10.
Remove the baery tab to apply power to the LTX
dispenser.
8.
Check to ensure that the baery tab is
present. If the baery tab is not present,
place a baery tab into the slot before
proceeding to the next step.
9.
Insert the module cable into the jack on the
front of the pump house, and press in rmly
to secure the plug.
11.
Load the dispenser with an appropriate product rell if needed. Close the dispenser door and watch for the
green light to start ashing aer a few seconds. If the light ashes red, or does not ash at all, reopen the
door and check for problems.
Status light
Baery tab