Gold Note PSU-10 - QUICK START; HOW TO POSITION PSU-10 & PSU-10 EVO

1 Turn OFF or disconnect the master unit
and remove the power cord.
2 Connect the external PSU to the power
outlet using the supplied power cord.
HOW TO POSITION PSU-10
& PSU-10 EVO
To achieve the best performance don’t place
the external PSU on top of the PH-10/DS-10
but on the left side.
Avoid placing the external PSU too close to
the PH-10/DS-10 if possible.
| QUICK START
5
3 Connect the external PSU to the master
unit using the supplied cable (from PSU
OUT to the PSU port on master unit).
4 Turn on the MASTER SWITCH on the rear
panel of the external PSU.
Installing the PSU-10/PSU-10 EVO is simple and takes only a few quick steps:
DS-10
PH-10
PSU-10 EVO
PSU-10